Otdr Testing Launch Cable

Attach launch reference cable to otdr and to cable plant under test.

Otdr testing launch cable.

Use of the receive reference cable is optional it is required if the far end connector loss is to be measured and included in total cable plant loss 2. Let s see how well you understand otdrs. The launch cable sometimes also called a pulse suppressor allows the otdr to settle down after the test pulse is sent into the fiber and provides a reference connector for the first connector on the cable under test to determine its loss. Attach cable to test to end of launch cable.

What is a launch cable used for. Attach receive cable if used to far end of cable. Attach launch cable to otdr. The launch fiber cable helps to negate blind spots or the dead zones of an otdr which occures when there is high launch power or faults near the.

The length of the launch and receive cables depends on the link being tested. Otdrs use the in the fiber to make measurements. Attenuation and event deadzones explained make sure that the otdr launch fiber used is of the same core diameter and connector type as the fiber link under test. Using a shorter fiber launch cable may hide the first event within the fiber quickmap s dead zone.

Quiz we have covered optical time domain reflectometer otdr testing a few times this year. Set up test parameters on otdr. Both a launch and receive cable are needed to measure complete link loss of a fiber with an otdr. Acquire trace and analyze.

Options for testing 1. Otdrs are always used with a launch cable and may use a receive cable. Measurement using a launch cable launch cable launch cable otdr 1m patchcord bulkhead reflective event with loss fiber under test start of fut end of fut end of launch cable these reflections will be small if the connectors are clean in good condition clean protect the launch cable connectors 1m patchcord. This help to avoid variations in loss and distance measurements when testing.

Fiber ring otdr launch cable connects the otdr to the link under test and relays insertion loss and reflectance of the near end connection. Attach receive cable if used to far end of cable. The launch cable is the link between the otdr test port and the fiber link being tested it is used to stabilize the test pulse and to enable the otdr to recover from transmitting the test pulse in order to see or characterize the first connector of the fiber under test. Otdr testing with launch and receive cable.

Because very long test cables are impractical to transport and use noyes designed coiled lengths of 50 µm multimode 62 5 µm multimode or single mode fiber conveniently packaged in compact rings. Attach optional receive cable to far end of cable under test. Noyes fiber rings from afl are a necessity when testing with an otdr.